RFTXX-30TA1432-10 Microstrip Attenuator With Sleeve RF Attenuator

Model: RFTXX-30TA1432-10 (XX=Attenuation value)

Resistance Range: 50 Ω

Frequency Range: DC~10.0 GHz

Power: 30 W

Attenuation(dB): 01-10/11-20/21-30/40、50、60

Attenuation Tolerance(dB): ±0.5/±0.6/±1.0/±1.2

VSWR: 1.25 type 1.3 max

Temperature Coefficient: <150ppm/℃

Substrate material: BeO

Sleeve Material: Al (Conductive oxidation)

Resistance Process: Thick Film

Operating Temperature: -55 to +125°C (See de Power De-rating)

ROHS Compliant: Yes

Send email to us sales@rftyt.com

Product Detail

Product Tags

Outline Drawing (Unit: mm/inch)

Diameter tolerance: ±0.05, length tolerance: ± 0.05

Typical Performance:

3dB Graph

10dB Graph

6dB Graph

20dB Graph

Use Attention

Power De-rating

1.Elastic contact is used at the contact point between the connector and the sleeve electrode;
2.The inner hole of the radiator should match the diameter of the sleeve, and the tolerance should not be too large;
Operation steps:
A. Tighten one end of the connector with a thread to one end of the radiator;
B. Place the sleeve type attenuation plate into the internal hole of the radiator;
C. Then tighten the connector on the other end with a thread
D. Attention: Thread requires the use of thread sealant

P/N Designation

Notes

■ The sleeve and radiator need to be tightly connected to ensure heat dissipation.
■ Good grounding is required to ensure S parameters.
■ In order to meet the requirements of the drawings,
it is necessary to install radiators of sufficient size.
■ If necessary, increase air cooling or water cooling.
■ The connection between the connector and the sleeve type attenuation electrode must use elastic contact.
■ If the sleeve is marked with "IN", be sure to place one end of the IN on the input port, and if there is no label, it will be bidirectional.
◆Remarks:
■ We can provide customized RF attenuators, RF resistors, coaxial dummy(termination) loads, and mismatched dummy(termination) loads.