-
-
MT-100WXX-F1116-NJ-XXG Mismatch Termination
Use attention Power De-rating P/N Designation -
MT-50WXX-F6080-NJ-XXG Mismatch Termination
Use attention Power De-rating P/N Designation -
Leaded Attenuator
Leaded Attenuator is an integrated circuit widely used in the electronic field, mainly used to regulate and reduce the strength of electrical signals. It plays an important role in wireless communication, RF circuits, and other applications that require signal strength control.
Leaded Attenuators are typically made by selecting appropriate substrate materials {typically aluminum oxide(Al2O3), aluminum nitride(AlN), beryllium oxide(BeO), etc.} based on different power and frequency, and using resistance processes (thick film or thin film processes).
Custom design available upon request.
-
MT-10WXX-R3540-NJ-XXG Mismatch Termination
Use attention Power De-rating P/N Designation -
CT-50W-RX5015-IP65-DINJ 0.35-4G Low Intermodulation Termination
Use attention Power De-rating P/N Designation -
CT-50W-RX5015-IP65-4310J 0.35-4G Low Intermodulation Termination
Use attention Power De-rating P/N Designation -
CT-02W-RA0612-1.85J-67G Coaxial Fixed Termination
Use attention Power De-rating P/N Designation -
CT-02W-RA0612-1.85J-67G Coaxial Fixed Termination
Use attention Power De-rating P/N Designation -
RFT50-20TM7750(R,L) Flanged Termination
Typical Performance: Installation method Power De-rating P/N Designation Matters needing attention ■ After the storage period of newly purchased parts exceeds 6 months, attention should be paid to weldability before use. It is recommended to store in vacuum packaging. ■ The ground requires optimal heat transfer. ■ Manual welding should be used under a constant temperature soldering iron of no more than 350 degrees, and the welding time should be controlled within 5 seconds. ■ In order to m... -
RFT50-10TM7750(R,L) Flanged Termination
Typical Performance: Installation method Power De-rating P/N Designation Matters needing attention ■ After the storage period of newly purchased parts exceeds 6 months, attention should be paid to weldability before use. It is recommended to store in vacuum packaging. ■ The ground requires optimal heat transfer. ■ Manual welding should be used under a constant temperature soldering iron of no more than 350 degrees, and the welding time should be controlled within 5 seconds. ■ In order to m... -
RFT50A-05TM1104 Flanged Termination
Typical Performance: Installation method Power De-rating P/N Designation Matters needing attention ■ After the storage period of newly purchased parts exceeds 6 months, attention should be paid to weldability before use. It is recommended to store in vacuum packaging. ■ The ground requires optimal heat transfer. ■ Manual welding should be used under a constant temperature soldering iron of no more than 350 degrees, and the welding time should be controlled within 5 seconds. ■ In order to m...
